Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual page 113

Appendix F Priming Lightweight Access Points Prior to Deployment
If the operating system download is successful, the lightweight access point reboots. Normal operation
Step 6
is indicated when the radio LED is blinking to indicate radio activity.
Step 7 Use controller CLI, controller GUI, or Cisco WCS to configure the lightweight access point with
primary, secondary, and tertiary controller names.
Step 8 If the lightweight access point is in a Controller Mobility Group, use the controller CLI, controller GUI,
or Cisco WCS to configure the Controller Mobility Group name.
Use controller CLI, controller GUI, or Cisco WCS to configure the access point-specific 802.11a,
Step 9
802.11b, and 802.11g network settings.
If the configuration priming was successful, the radio LED is blinking to indicate normal operation.
Step 10
Repeat Steps 4 to 9 for each access point.
Step 11
When you successfully complete the configuration priming of all your lightweight access points, ensure
Master setting is disabled on your controller. You can begin deploying the access points to their final
destinations.
OL-8369-05
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
F-3