Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual page 76

Checking the Lightweight Access Point LEDs
The LED signals are listed in
Table 4-1 LED Signals
Message type
Boot loader status
Association status
Operating status
Boot loader warnings
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
4-4
Cable Bay Area
Ethernet LED Radio LED
Green Green
Off Blinking
green
Off Green
Green Off
Green Green
— —
— —
Green —
Blinking —
green
— Blinking
green
— —
Slow —
blinking
green
Off Off
Red Off
Amber Off
Off Red
Blinking Blinking red Blinking
green
Table 4-1.
Top of Unit
Status LED Meaning
Green DRAM memory test ok.
Blue-green Initialize Flash file system.
Pink Flash memory test ok.
Dark blue Ethernet test ok.
Green Starting Cisco IOS.
Light green Normal operating condition, but no wireless client
devices are associated with the unit.
Blue Normal operating condition, at least one wireless
client device is associated with the unit.
— Ethernet link is operational.
— Transmitting or receiving Ethernet packets.
— Transmitting or receiving radio packets.
Blinking Software upgrade in progress
dark blue
— Hybrid-REAP standalone mode
Yellow Ethernet link not operational.
Yellow Ethernet failure.
Yellow Configuration recovery in progress
(Mode button pressed for 2 to 3 seconds).
Pink Image recovery
(Mode button pressed for 20 to 30 seconds)
Image recovery in progress and Mode button is
pink released.
Chapter 4 Troubleshooting Lightweight Access Points
OL-8369-05