Checking The Autonomous Access Point Leds - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Checking the Autonomous Access Point LEDs

Checking the Autonomous Access Point LEDs

If your autonomous access point is not working properly, check the Status LED on the top panel or the
Ethernet and Radio LEDs in the cable bay area. You can use the LED indications to quickly assess the
unit's status.
using the access point browser interface).
Figure 3-1
1
2
To view the Ethernet and Radio LEDs you must open the access point cover (refer to the
Note
Access Point Cover" section on page
When the access point cover is opened, the Status LED colors are not visible.
Note
Regarding LED status colors, it is expected that there will be small variations in color intensity and hue
Note
from unit to unit. This is within the normal range of the LED manufacturer's specifications and is not a
defect.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-2
Figure 3-1 shows the access point LEDs (for additional information refer to the Event Log
Access Point LEDs
2
3
4
Status LED
Access point cover
Chapter 3
1
3
Ethernet LED
4
Radio LED
2-11).
Troubleshooting Autonomous Access Points
"Opening the
OL-8369-05