Mounting Below A Suspended Ceiling - Cisco Aironet 1130AG Series Hardware Installation Manual

Chapter 2 Installing the Access Point
Position the mounting plate over the wall anchors or the drilled holes.
Step 5
Insert two
Step 6
To attach the access point to the mounting plate, see
section on page

Mounting Below a Suspended Ceiling

You should review
Figure 2-8
1
2
Follow these steps to mount your access point on a suspended ceiling:
Decide where you want to mount the access point on your suspended ceiling.
Step 1
Select the appropriate adjustable T-rail clip for your suspended ceiling and open the clip to the maximum
Step 2
(see
Unscrew the two T-rail locking set screws to enable placing the clip over a T-rail.
Step 3
OL-6226-01
C I S C O C O N F I D E N T I A L -
8x32x1inch pan head screws in the X mounting holes and tightening.
2-16.
Figure 2-8 before beginning the mounting process.
Adjustable T-Rail Clips
T-rail locking set screw
Mounting plate screw holes
Figure 2-4).
D r a f t 2
"Attaching the Access Point to the Mounting Plate"
3 T-rail width detents (A, B, or C)
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Mounting the Access Point
2-11