Mounting Access Point On A Network Cable Box; Mounting Access Point On A Desktop Or Shelf; Attaching The Access Point To The Mounting Plate - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Mounting Access Point on a Network Cable Box

Connect a drop wire to a building structural element and the hole provided in the bracket mounting clip.
Step 8
This additional support is required in order to comply with the U.S. National Electrical Safety Code.
Step 9 If you need additional security, you can secure the access point to a nearby immovable object using a
Kensington lock and security cable (see the
Step 10 Verify that the access point is operating before replacing the ceiling tile.

Mounting Access Point on a Network Cable Box

Follow these steps to mount the access point on a network cable box.
Position the mounting plate over the network cable box and align the two mounting holes (labled with
Step 1
an X) with the network cable box holes.
Hold the mounting plate and insert a 6 x 32 x 1/4 in. pan head screw into each of the two X mounting
Step 2
holes and tighten.
Pull the access point cables out of the network box until there is about 1 foot of exposed cables
Step 3
protruding from the box.
To attach the access point to the mounting plate, see the
Plate" section on page

Mounting Access Point on a Desktop or Shelf

When placing the access point on a desktop of shelf, you do not need the mounting plate. The access
point has four rubber pads on the bottom to help prevent sliding or scratching the surface of your desktop
or shelf. For information on connecting the access point cables, see the
Power Cables" section on page

Attaching the Access Point to the Mounting Plate

Follow these steps to attach the access point to the mounting plate:
Step 1 Open the access point cover (see the
Step 2 In the cable bay area, pull the cables through the access point cable opening (see
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-16
"Securing the Access Point" section on page
2-16.
2-21.
"Opening the Access Point Cover" section on page
Chapter 2 Installing the Access Point
"Attaching the Access Point to the Mounting
"Connecting the Ethernet and
Figure
2-18).
2-11).
2-5).
OL-8369-05