Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual page 63

Chapter 3 Troubleshooting Autonomous Access Points
Table 3-3 Access Point System Power Settings and Cisco Switch Commands (continued)
Power Source
2
Power injector used with a
Cisco switch that supports
Intelligent Power Management
2
Power injector used with a
Cisco switch that does not
support Intelligent Power
1
Management
Power injector used with a
non-Cisco switch
802.3af compliant non-Cisco
switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Follow these steps to configure your access point power settings using the browser interface:
Obtain the access point IP address and browse to your access point.
Step 1
At the prompt, enter the administrator username and password. The default username is Cisco and the
Step 2
default password is Cisco. The username and password are case sensitive.
Choose one of these operations:
Step 3
a.
b.
Choose one of these Power Settings options (see
Step 4
a.
b.
c.
OL-8369-05
Access Point System Power Settings
Power Settings:
Power Negotiation (selected)
1
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (checked)
Configuration changes are not required
Configuration changes are not required
When you browse to your access point operating in low-power mode, a Warning message appears
indicating that all radios are disabled due to insufficient power. Click OK to jump to the System
Power Settings located on the System Software > System Configuration page.
When you browse to your access point operating in full-power mode, choose System Software >
System Configuration.
If your Cisco switch supports Intelligent Power Management negotiations, choose Power
Negotiation.
If your Cisco switch does not support Intelligent Power Management negotiations, choose
Pre-standard Compatibility.
If you are using a non-Cisco switch, changes to the power settings are not required.
Low Power Condition for Autonomous Access Points
Figure 3-2):
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Cisco Switch
Power Command
3
power inline never
power inline never
–
–
3-13