C H A P T E R 3 Troubleshooting Autonomous Access Points - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 3 Troubleshooting Autonomous Access Points
The LED signals are listed in
Table 3-1 LED Signals
Message type
Operating status
Association status
Cisco IOS errors
Boot loader status
Boot loader warnings
OL-8369-05
Cable Bay Area
Ethernet LED Radio LED
Green —
Blinking green —
— Blinking green —
— —
— —
— —
Blinking amber —
— Blinking amber —
Red Red
— —
Green Green
Off Blinking green Blue-green
Off Green
Green Off
Green Green
Off Off
Red Off
Amber Off
Off Red
Blinking green Blinking red
Table 3-1.
Top of Unit
Status LED Meaning
— Ethernet link is operational.
— Transmitting or receiving Ethernet packets.
Transmitting or receiving radio packets.
Blinking Software upgrade in progress
dark blue
Light green Normal operating condition, but no wireless
client devices are associated with the unit.
Blue Normal operating condition, at least one wireless
client device is associated with the unit.
— Transmit or receive Ethernet errors.
Maximum retries or buffer full occurred on the
radio.
Amber Software failure; try disconnecting and
reconnecting unit power.
Amber General warning, insufficient inline power (see
the
Access Points"
Green DRAM memory test ok.
Initialize Flash file system.
Pink Flash memory test ok.
Dark blue Ethernet test ok.
Green Starting Cisco IOS.
Yellow Ethernet link not operational.
Yellow Ethernet failure.
Yellow Configuration recovery in progress
(Mode button pressed for 2 to 3 seconds).
Pink Image recovery
(Mode button pressed for 20 to 30 seconds).
Blinking Image recovery in progress and Mode button is
pink released.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Checking the Autonomous Access Point LEDs
"Low Power Condition for Autonomous
section).
3-3