Manually Configuring Controller Information Using The Access Point Cli - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Manually Configuring Controller Information Using the Access Point CLI

Refer to
corresponding Cisco switch power command.
Table 4-2 Using CLI Power Commands
Power Source
AC power module
Cisco switch that supports Intelligent Power
1
Management
Cisco switch that does not support Intelligent
1
Power Management
2
Power injector used with a Cisco switch that
supports Intelligent Power Management
2
Power injector used with a Cisco switch that
does not support Intelligent Power
1
Management
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Manually Configuring Controller Information Using the Access
Point CLI
In a new installation, when your access point is unable to reach a DHCP server, you can manually
configure needed controller information using the access point CLI. For information on how to connect
to the console port, see the
The CLI commands in this section can be used only on an access point that is not associated to a
Note
controller.
The static information configured with the CLI commands are used by the access point to connect with
a controller. After connecting with the controller, the controller reconfigures the access point with new
controller settings, but the static IP addresses for the access point and the default gateway are not
changed.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
4-8
Table 4-2 for information on when to use these special CLI controller commands and the
Cisco Wireless LAN Controller
None required
None required
config ap power pre-standard enable
None required
1
config ap power injector enable
None required
None required
"Connecting to the Access Point Console Port" section on page
Chapter 4 Troubleshooting Lightweight Access Points
CLI Commands
Cisco Switch
power inline never
power inline auto
power inline auto
power inline never
power inline never
–
–
3
4-12.
OL-8369-05