Connecting The Ethernet And Power Cables - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 2 Installing the Access Point

Connecting the Ethernet and Power Cables

The access point receives power through the Ethernet cable or an external power module.
shows the power options for the access point.
Figure 2-14
SYST 1
RPS 2
STAT UTIL DUPLX
SPEED
MODE
This product must be connected to a Power over Ethernet (PoE) IEEE 802.3af compliant power source
Warning
or an IEC60950 compliant limited power source. Statement 353
The access point supports the following power sources:
•
•
Note Some older switches and patch panels might not provide enough power to operate the access point. At
power-up, if the access point is unable to determine that the power source can supply sufficient power,
the access point automatically deactivates both radios to prevent an over-current condition. The access
point also activates a Status LED low power error indication and creates an error log entry (refer to the
"Low Power Condition for Autonomous Access Points" section on page 3-6
Condition for Lightweight Access Points" section on page
OL-8369-05
Access Point Power Options
Option 1
Switch with
inline power
3
4 5
6
7
8 10Base -T
9 10 / 100Bas
11 e-TX
12
13 14
15
16
17
18 19 Cataly st 2950
20
21 SERIES
22
23 24 100Bas e-FX
23
24
Access Point
Power module
Inline power:
Cisco Aironet Power Injector (AIR-PWRINJ3 or AIR-PWRINJ-FIB)
–
An inline power capable switch, such as the Cisco Catalyst 3550 PWR XL, 3560-48PS,
–
3570-48PS, 4500 with 802.3AF PoE module, or the 6500 with 802.3AF PoE module
Other inline power switches supporting the IEEE 802.3af inline power standard
–
4-6).
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Connecting the Ethernet and Power Cables
Figure 2-14
Option 2
Switch
(without inline power)
SYST 1
RPS 2
3 4
STAT 5
UTIL DUPLX SPEED 6
7
8 9 10Base -T
MODE 10 / 100Bas e-TX
11
12 13
14
15
16
17 18
19 Cataly st 2950
20 SERIES
21
22 23 100Bas e-FX
24
23
24
Power injector
Power
cord
Universal
power supply
Option 4
or the "Low Power
2-21