Table of Contents
Advertisement
Control Panel Installation
ON
OFF
Refer to Section 8.2 to edit, add, delete, and view module list.
4.14 Telephone Connection
Connect the telephone lines as shown in Figure 4.39. Model 7860 phone cord is available from Honeywell for this purpose.
A number of programmable options are available for customizing the telephone lines. These options are described in Section 8.6.
4.15 Notification Appliance/Auxiliary Power Circuits
Two outputs are built-in to the IFP-75 FACP which can be programmed to be used as NACs (Class A or Class B) or as aux power. This sec-
tion of the manual explains how to install conventional notification appliances and how these terminals can be used for auxiliary power.
NOTE: Where power to a device or appliance is supplied over a separate pathway from the notification appliance and/or SLC, the operation of
the power pathway shall meet the performance requirements of the, notification appliance, and/or signaling-line circuit(s) and the power circuit
shall be defined by the applicable class in the product installation wiring diagram/instructions consistent with the operation of the particular
power pathway.
48
address
1
2 3
1
2 3
4 5 6
Figure 4.38 Possible SBUS Module Addresses
Model
#7860
Figure 4.39 Connection of Telephone Lines
address
4 5 6
1
2 3
4 5 6
NO
Model
#7860
IFP-75 Series Manual — P/N LS10147-001SK-E:E 4/6/2022
address
address
1
2 3
4 5 6
RELAY 2
RELAY 1
TROUBLE
C
NC
NO
NO
C
NC
Telephone Connection
C
NC
Advertisement
Table of Contents
Troubleshooting
