Test start points
You can check whether the lawnmower can correctly return to the docking
station, and whether it can reach each start points according to settings.
Test start points
Home screen
[1.Point1] to [3.Point 3] (HRM1000, HRM1500, HRM1500 Live) or
[5.Point 5] (HRM2500, HRM2500 Live)
You can configure 3 start points(HRM1000,
HRM1500, HRM1500 Live) or 5 start
points(HRM2500, HRM2500 Live).
You can test that the lawnmower reach each start
points according to settings.
NOTE:
- Perform this test when the lawnmower is connected
to the docking station.
Menu screen
[3.Diagnostics]
J
[2.Test start points]
J
Select a point from 1 to 3 or 5 which you
1
want to test and press the H button.
Confirm the value of the selected point
2
settings.
Close the control panel cover.
3
The lawnmower starts to the selected start
point.
When the test is correctly finished, the
lawnmower rolls slowly from side to side
showing the minimum and maximum exit
angle, and a beep sound is emitted from the
lawnmower.
Press the manual STOP button.
4
The control panel cover pops up.
The message "Do you want to modify the
start point?" appears on the display.
Select [Yes] or [No] to the question and
5
press H button.
If you select [Yes], Start point screen
appears. You can modify the settings of the
tested start point.
If you select [No], the previous screen
appears.
NOTE:
- For details on the start point settings,
see "2. Setting the start points" (M
page 34).
Checking the system
J
69