Honda Miimo HRM1000 Owner's Manual page 102

Message
Obstruction An obstruction is being detected, or
the sensor detects something.
detection
Outside loop The lawnmower exited the boundary
wire.
Tire slip
The lawnmower has detected tire slip.
Upside down
The lawnmower is upside down.
Contact your dealer if the following messages have appeared.
*Auto power off
Battery Error
Battery temperature
Blade motor
Blade motor blocked
Bluetooth communication
Charging control
Clock
It may be necessary to exchange the battery. Contact your dealer with the operating history ready (cutting
time, charging time, returning time).
Cause
Enter the PIN so that the message disappears.
If the message does not disappear, contact your
dealer.
Move the lawnmower into the work area.
Check the power supply of the docking station.
Check if the boundary wire connectors are
correctly connected.
If the message does not disappear, check if
the boundary wire connectors are correctly
connected, and check if there are no similar
lawnmowers in the area or any electronic device
or electrical installation that could interfere with
the lawnmower signal.
If the message still does not disappear, contact
your dealer.
Measure the depth of the groove in the center of
the rear wheel (tire). If it is 3 mm or less, contact
your dealer or authorized service agent for
replacement.
Place the lawnmower on a flat surface, and enter
the PIN so that the message disappears. If the
message does not disappear, contact your dealer.
Communication Error
Data memory Error
Display Unit Error
IMU sensor
Lift sensor
Manual stop
Motor ECU Error
Motor relay
Messages
Solution
Motor sensor Blade
Motor sensor L
Motor sensor R
Rollover sensor
Stop SW
Tilt sensor
Wheel motor
Wheel motor blocked
99