Overview; How The Honda Robotic Lawnmower Works - Honda Miimo HRM1000 Owner's Manual

How the Honda Robotic Lawnmower works

1

OVERVIEW

How the Honda Robotic Lawnmower works
The mowing area is determined by the boundary wire that emits a signal; when the
lawnmower detects the boundary it turns and it cuts the grass randomly. When battery
starts running out, it goes back to the docking station.
If Mii-monitor is installed on a smartphone connected to mobile network, you can configure settings and
check error notifications from any remote location (HRM1500 Live, HRM2500 Live).
Pegs
Boundary wire
Lay the boundary wire by burying it under the
ground, or securing it on the ground with pegs.
Maximum area:
1000 m (HRM1000)
2
1500 m (HRM1500, HRM1500 Live)
2
3000 m (HRM2500, HRM2500 Live)
2
Maximum possible length:
400 m(HRM1000, HRM1500, HRM1500 Live)
4
800 m(HRM2500, HRM2500 Live)
AC adapter
The AC adapter must be installed in a shaded area protected from rain.
Install and fix the AC adapter on the wall at a minimum height of 30cm from the
ground.
Connect the AC adapter to the power supply after all connections are
completed.
Docking station
The docking station should be placed on level ground,
and the height difference between the front and back of
the docking station should not exceed 5°. For details,
see "Installation" (
Power cord
Robotic Lawnmower
Free zone (HRM1500 Live, HRM2500 Live only)
Use GPS to set areas where you want to reduce
the frequency of the lawnmower intrusion (for
planned activities or if the user requires an area to
continue to grow).
For details, see "GNSS" (M page 61).
M page 16
).
There are various ways to install the
docking station. For details, see "Checking
conditions for installation" (M page 16).
Shortcut wire (HRM1500, HRM1500
Live, HRM2500, HRM2500 Live
only)
The Shortcut wires are laid in the
ground or fixed to the ground with
wire pegs.
Lay the shortcut wire at a bending
angle of 90° or more.