Honda Miimo HRM1000 Owner's Manual page 35

Setting up the lawnmower
1.
Setting the garden layout
Through this setting, you can configure the information of your garden layout for operating the lawnmower.
[1.Garden layout] is selected. Press the H button to
1
1-
configure the garden layout.
Garden layout screen is displayed.
Select the signal type and number of the shortcut
2
1-
wire (excepted for HRM1000), and press the H
button. Then select [NEXT] and press the H button.
[Dock the mower in the station] is displayed.
Place the lawnmower in the docking station.
3
1-
[Please wait...] is displayed and then [Finish] is
displayed.
If the mower is set in the docking station, part it from the
station and set it in the station again.
[NEXT] is selected, press the H button.
4
1-
The [Docking direction] select screen is displayed.
Select an installation pattern for the docking
5
1-
station, and press the H button.
Refer to page 16, to confirm which pattern matches your
actual installation.
Enter the values of the boundary wire length and
6
1-
garden size, [NEXT] is selected, press the H button.
NOTE:
- For details on the boundary wire length or
garden size, contact your dealer.
- Input the boundary wire length exactly because
the values which are automatically configured
are associated with the boundary wire length.
32
Setup wizard
1.G arden lay ou t
2.Start points
3.T es t s tart points
4.Work timer
Garden layout
Signal type
A B
Shortcut wire quantity
0 1
HRM1500, HRM1500 Live
Garden layout
Docking direction
HRM2500, HRM2500 Live
Garden lay out
Docking direction
Garden layout
Boundary wire length
_ _0m (50–800m)
Garden size
_ _00m (100–3000 m
1/4
1/4
C D
NEXT
1/4
1/4
1/4
)
2
NEXT