Messages - Honda Miimo HRM1000 Owner's Manual

Messages

Messages
If any of the following messages appear in the display, use this troubleshooting guide to address the
problem before contacting your dealer. If the problem persists, contact your dealer.
Message
*Lock out display
Area signal lost
Battery capacity
low
Battery capacity
reduced
Battery temp
high
Battery temp low (1)
Battery temp low (2)
Battery voltage
high (1)
Battery voltage
low
Blade motor
temp high
Clock reset
ENT key
Excessive tilt
Key pad
Mower lifted
No boundary
signal
98
Cause
The PIN code is incorrect.
The lawnmower does not detect the
boundary wire signal.
The battery does not charge enough.
The battery does not charge enough.
The battery temperature is too high.
The battery temperature is too low.
The battery charges too much.
The battery does not charge enough.
The temperature of the blade motor is
or exceeds 85°C.
The backup battery power has drained
during long-term storage. The clock
has been reset.
The H (Enter) button was pressed
while the lawnmower was running
(with the control panel cover closed).
The lawnmower is in an excessively
tilted area.
A button was pressed while the
lawnmower was running (with the
control panel cover closed).
The cover has been lifted by
something, e.g. a stone.
The lawnmower does not detect the
boundary wire signal.
Solution
Please enter the correct PIN code.
If you forget your PIN, contact your dealer.
Check if the boundary wire connectors are
correctly connected. If the message does not
disappear, contact your dealer.
Increase the remaining capacity of homing. See
"Homing setup" (M page 65). If the message does
not disappear, contact your dealer.
Set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Put the lawnmower in a place where the
temperature 5°C or higher, set the power to ON,
and wait until the message disappears.
If the message does not disappear, contact your
dealer.
Remove the lawnmower from the docking station,
set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Charge the lawnmower with the docking station.
This message disappears if the battery is charged
more than 10%.
If the message does not disappear, contact your
dealer.
Leave the power ON and the control panel cover
open, and wait 15 to 30 minutes until the message
disappears. If the message does not disappear,
contact your dealer.
Set the current date and time. The time must be in
24-hour format.
If the clock cannot be set, contact your dealer.
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Place the lawnmower on a flat surface, and enter
the PIN so that the message disappears. If the
message does not disappear, contact your dealer.
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Enter the PIN so that the message disappears.
If the cover is heavily damaged or the message
does not disappear, contact your dealer.
Check if the boundary wire connectors are
correctly connected.
Check a power supply of docking station. See
"Test start points" (M page 69). If the message
does not disappear, contact your dealer.