Table of Contents
Advertisement
Service and Repair
8.
Cut the pad at the mark, leaving a 1/16-inch gap between the ends.
9.
Chamfer the edges 1/8-inch at a 45° angle.
10.
Make a splice connection by inserting a 7/8-inch long piece of 1/4-inch OD air hose
tubing into both ends of the driver pad.
Note: If preferred, use air tubing cutters for a straight and clean cut.
11.
Firmly push the pad (and splice connection) onto the chain pins.
12.
Remove all dirt and oil from the pad using a clean shop towel and a suitable cleaner
such as a good glass/window cleaner. Avoid harsh chemicals or oil, which will
degrade the pad.
13.
Install the carrier rollers.
14.
Remove lockout/tagout and restore power.
15.
Make sure the driver chain and driver pad are operating correctly.
Note: If a short section of the driver pad is damaged, replace by cutting it away and
splicing a new length of pad. Ensure the spliced section of the driver pad is at least
10 feet long.
Pallet Accuglide ZoneFlex Accumulation Conveyor
52
Maintenance Manual
|
| 29334206
February 14, 2018
Advertisement
Table of Contents
Troubleshooting
