Roll Gain - Honeywell BENDIX/KING RDR 2000 Installation Manual

BENDIX/KING
2. Adjust the GAIN knob for a GAIN POT setting between -24.5 and -26.5 (see
2-10). An 02 should be displayed in the AZIMUTH COUNT field
3. Adjust the TILT SETTING between 5 and 10 UP to increment the PITCH ANGLE
field to 10.0 ± 1.0
rement the numbers). Upon reaching the desired setting, quickly adjust the TILT
SETTING to above 10 to lock in the setting. See
°
4. Set to 5 PITCH DOWN and repeat steps 2 and 3 of this section.
5. Set the tilt table to 0
6. Proceed to Step O.
O. ROLL GAIN
1. In determining the tilt for the table use the standard rate turn for the aircraft being
aligned.
2. Adjust the GAIN knob for a GAIN POT setting between -21.0 and -23.0 (see
2-10). An 03 should be displayed in the AZIMUTH COUNT field
3. Adjust the TILT SETTING between 5 and 10 UP to increment the ROLL ANGLE
field to 10.0 ± 1.0
rement the numbers). Upon reaching the desired setting, quickly adjust the TILT
SETTING to above 10 to lock in the setting. See
°
4. Set to 10 roll left. Repeat steps 2 and 3 of this section.
5. Set the tilt table to 0
6. Proceed to Step R.
P. AHRS ARINC 429 PITCH OFFSET
1. Adjust the GAIN knob for a GAIN POT setting between -10.5 and -12.5 (see
2-10). An 06 should be displayed in the AZIMUTH COUNT field
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5 and 10 UP to increment the PITCH ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0
to above 10 to lock in the setting. See
4. Set the tilt table to 10
out of range, repeat Steps 1, 2, and 3 of this section.
5. Set the tilt table to 10
is out of range, repeat Steps 1, 2, 3, and 4 of this section.
6. Set the tilt table to 0
Rev 7, July/2002
°
(adjusting the TILT SETTING between 5 and 10 DOWN will dec-
°
pitch and roll.
°
(adjusting the TILT SETTING between 5 and 10 DOWN will dec-
°
pitch and roll.
°
pitch.
°
(adjusting the TILT SETTING between 5 and 10 DOWN will dec-
°
pitch up. The value should be 10.0U ± 1.0
°
pitch down. The value should be 10.0D ± 1.0
°
pitch. The value should be 0.0 ± 1.0
00643I05.TDC
figure 2-11.
figure 2-11.
° °
± 1.0 , quickly adjust the TILT SETTING
figure 2-11.
°
.
RDR 2000
figure
(see table 2-2).
figure
(see table 2-2).
figure
(see table 2-2).
°
. If the value is
°
. If the value
Page 2-29