Art 2000 Dipswitch Settings - Honeywell BENDIX/KING RDR 2000 Installation Manual

BENDIX/KING
Function
1. Transmit enable
2. Antenna scan enable
3. Factory Calibration
4. Antenna size used in con-
nection with (5)
5. Antenna size used in con-
nection with (4)
6. TTR request
7. Quiet startup enable
8. Factory Calibration
2.3.3.1 Antenna
Either a 10-inch or 12-inch flat plate antenna must be attached to the radar receiver-transmitter.
See figures 2-33, 2-34, 2-35, and 2-36.
A vertically polarized antenna will give the best radar performance. However, clearance restric-
tions in specific applications may necessitate the use of one of the other antenna options. See
figures 2-29, and 2-30, ART 2000 Outline and Mounting Drawing.
The ART 2000 is shipped with a cover plate over the port opening on the microwave assembly.
This cover plate must be removed and discarded. A 9/64" ball end Allen driver is needed for in-
stallation and removal of the antenna on all ART's. Proceed as follows to install the antenna.
Rev 7, July/2002
Function when on
Transmitter is enabled
Antenna scans normally
Factory calibration
(4) on (5) on 10" slotted or
12" microstrip antenna
(4) on (5) off 18" slotted
antenna (future expansion)
Factory diagnostics
Antenna motion initiated
using sensors
Factory calibration
Table 2-1

ART 2000 dipswitch settings

Before installing the ART 2000 antenna (071-01519-
0101), a sticker on the radar's microwave assembly
must be removed. Once this sticker is been removed
the surface must be cleaned. Cleaning must be done
with Isopropyl alcohol and a cotton cloth to insure
that all adhesive is removed from the radar's micro-
wave assembly. Caution must be given not to allow
debris to enter the microwave assembly cavity. This
cleaning process must be followed every time the
protective sticker is removed and just before installa-
tion of the antenna.
00643I05.TDC
Transmitter is displayed "Tx
Flt" displayed
Antenna motors are disabled
Normal operation
(4) off (5) on 12" slotted
antenna
(4) off(5) off 10" microstrip
antenna
Normal operation
Antenna hall sensors are not
used and attempt to recali-
brate
Normal operation
NOTE:
RDR 2000
Function when off
Page 2-3