Honeywell BENDIX/KING RDR 2000 Installation Manual page 55

BENDIX/KING
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5° and 10° UP to increment the ROLL ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0
to above 10° to lock in the setting. See
4. Set the tilt table to 10° roll right. The value should be 10.0R ± 1.0
5. Set the tilt table to 10° roll left. The value should be 10.0L ± 1.0
6. Set the tilt table to 0
7. Proceed to Step I.
I. PITCH GAIN
1. Set the tilt table for 5° PITCH UP.
2. Adjust the GAIN knob for a GAIN POT setting between -24.5 and -26.5 (see
2-10). An 02 should be displayed in the AZIMUTH COUNT field
3. Adjust the TILT SETTING between 5° and 10° UP to increment the PITCH ANGLE
field to 5.0 ± 1.0
rement the numbers).
Upon reaching the desired setting, quickly adjust the TILT SETTING to above 10
to lock in the setting. See
°
4. Set for 5 PITCH DOWN. Repeat steps 2 and 3.
5. Set the tilt table to 0
6. Proceed to Step J.
J. ROLL GAIN
1. In determining the tilt for the table use the standard rate turn for the aircraft being
aligned.
2. Adjust the GAIN knob for a GAIN POT setting between -21.0 and -23.0 (see
2-10). An 03 should be displayed in the AZIMUTH COUNT field
3. Adjust the TILT SETTING between 5° and 10° UP to increment the ROLL ANGLE
field to Standard Rate Turn (SRT) for the aircraft (adjusting the TILT SETTING be-
tween 5° and 10° DOWN will decrement the numbers). Upon reaching the desired
setting, quickly adjust the TILT SETTING to above 10° to lock in the setting. See
figure 2-11.
4. Set the tilt table for SRT roll left. Repeat Steps 2 and 3 of this section.
5. Set the tilt table to 0
6. Proceed to Step M.
Rev 7, July/2002
°
roll.
°
(adjusting the TILT SETTING between 5° and 10° DOWN will dec-
°
roll. The value should be 0.0 ± 1.0
°
(adjusting the TILT SETTING between 5° and 10° DOWN will dec-
figure 2-11.
°
pitch and roll.
°
pitch and roll.
00643I05.TDC
° °
± 1.0 , quickly adjust the TILT SETTING
figure 2-11.
°
.
RDR 2000
°
.
°
.
figure
(see table 2-2).
figure
(see table 2-2).
Page 2-25