Honeywell BENDIX/KING RDR 2000 Installation Manual page 56

BENDIX/KING
K. AHRS ARINC 429 PITCH OFFSET
1. Adjust the GAIN knob for a GAIN POT setting between -10.5 and -12.5 (see
2-10). An 06 should be displayed in the AZIMUTH COUNT field
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5° and 10° UP to increment the PITCH ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0
to above 10° to lock in the setting. See
4. Set the tilt table to 5
of range, repeat Steps 1, 2, and 3 of this section.
5. Set the tilt table to 5
of range, repeat Steps 1, 2, 3, and 4 of this section.
6. Set the tilt table to 0
7. Proceed to Step L.
L. AHRS ARINC 429 ROLL OFFSET
1. Adjust the GAIN knob for a GAIN POT setting between -7.0 and -9.0 (see
10). An 07 should be displayed in the AZIMUTH COUNT field
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5° and 10° UP to increment the ROLL ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0.0 ± 1.0
to above 10° to lock in the setting. See
4. Set the tilt table to 10
5. Set the tilt table to 10
6. Set the tilt table to 0
7. Proceed to Step M.
M. SAVE CONFIGURATION
1. Adjust the GAIN knob for a GAIN POT setting between -3.5 and -5.5 (see
10). An 08 should be displayed in the AZIMUTH COUNT field
2. Set the TILT SETTING to 15.0 DOWN. The fault fields will flash indicating the save
procedure is beginning. If the save procedure is successful, the GYRO fault will
disappear and the azimuth count will step.
3. If the GYRO remains unchanged, TILT to 0
Page 2-26
°
pitch.
°
(adjusting the TILT SETTING between 5° and 10° DOWN will dec-
°
pitch up. The value should be 5
°
pitch down. The value should be 5
°
pitch. The value should be 0.0 ± 1.0
°
roll.
°
(adjusting the TILT SETTING between 5° and 10° DOWN will dec-
°
roll right. The value should be 10.0R ± 1.0
°
roll left. The value should be 10.0L ± 1.0
°
roll. The value should be 0.0 ± 1.0
00643I05.TDC
° °
± 1.0 , quickly adjust the TILT SETTING
figure 2-11.
° °
± 1.0 .
°
± 1.0
°
.
°
, quickly adjust the TILT SETTING
figure 2-11.
°
.
°
and repeat Step 2.
RDR 2000
figure
(see table 2-2).
If the value is out
°
. If the value is out
figure 2-
(see table 2-2).
°
.
°
.
figure 2-
(see table 2-2).
Rev 7, July/2002