Pitch Gain; Pitch Offset - Honeywell BENDIX/KING RDR 2000 Installation Manual

BENDIX/KING
4. Proceed to Step L.
L. PITCH OFFSET
1. Adjust the GAIN knob for a GAIN POT setting between -17.5 and -19.5 (see
2-10). An 04 should be displayed in the AZIMUTH COUNT field
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5 and 10 UP to increment the PITCH ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0
to above 10 to lock in the setting. See
4. Set the tilt table to 10
5. Set the tilt table to 10
6. Set the tilt table to 0
7. Proceed to Step M.
M. ROLL OFFSET
1. Adjust the GAIN knob for a GAIN POT setting between -14.0 and -16.0 (see
2-10). An 05 should be displayed in the AZIMUTH COUNT field
2. Check that the tilt table is set for 0
3. Adjust the TILT SETTING between 5 and 10 UP to increment the ROLL ANGLE
field to 0.0 ± 1.0
rement the numbers). Upon reaching 0
to above 10 to lock in the setting. See
4. Set the tilt table to 10
out of range, repeat Step O.
5. Set the tilt table to 10
of range, repeat Step O.
6. Set the tilt table to 0
range, repeat Step P.
7. Proceed to Step N.
N. PITCH GAIN
1. Set the tilt table for 5
Page 2-28
If the 400 Hz REF field is zero (0), and will not
change when the TILT knob is adjusted, check that
the correct gyro has been selected when program-
ming the Configuration Module.
°
pitch.
°
(adjusting the TILT SETTING between 5 and 10 DOWN will dec-
°
pitch up. The value should be 10.0U ± 1.0
°
pitch down. The value should be 10.0D ± 1.0
°
pitch. The value should be 0.0 ± 1.0
°
roll.
°
(adjusting the TILT SETTING between 5 and 10 DOWN will dec-
°
roll right. The value should be 10.0R ± 1.0
°
roll left. The value should be 10.0L ± 1.0
°
roll. The value should be 0.0 ± 1.0
°
pitch up.
00643I05.TDC
NOTE
° °
± 1.0 , quickly adjust the TILT SETTING
figure 2-11.
°
.
° °
± 1.0 , quickly adjust the TILT SETTING
figure 2-11.
°
. If the value is out of
RDR 2000
figure
(see table 2-2).
°
.
°
.
figure
(see table 2-2).
°
. If the value is
°
. If the value is out
Rev 7, July/2002