NETGEAR Nighthawk RS700 User Manual page 52

After you click the Apply button, the router automatically detects the information in
the following fields:
• Router's IPv6 Address on WAN: This field shows the IPv6 address that is acquired
for the router's WAN (or Internet) interface. The number after the slash (/) is the
length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
• Router's IPv6 Address on LAN: This field shows the IPv6 address that is acquired
for the router's LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. Configure the login settings:
a. In the Login field, enter the login information for the ISP connection.
This is usually the name that you use in your email address. Some ISPs (like
Mindspring, Earthlink, and T-DSL) require that you use your full email address
when you log in. If your ISP requires your full email address, type it in this field.
b. In the Password field, enter the password for the ISP connection.
c. In the Service Name field, enter a service name.
If your ISP did not provide a service name, leave this field blank.
NOTE: The default setting of the Connection Mode menu is Always On
to provide a steady IPv6 connection. The router never terminates the
connection. If the connection is terminated - for example, when the modem
is turned off - the router attempts to reestablish the connection immediately
after the PPPoE connection becomes available again.
7. Select an IPv6 Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address. This option uses the DNS servers
assigned by the ISP for the IPv4 connection.
• Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it also.
8. Select an IP Address Assignment radio button:
• Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive the IPv6 address through a
DHCP server.
• Auto Config: This is the default setting.
Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
52 User Manual