Set A Dhcp Ipv6 Internet Connection - NETGEAR Nighthawk RS700 User Manual

NOTE: If you do not specify the DNS servers, the router uses the DNS
servers that are configured for the IPv4 Internet connection on the Internet
Setup page. (See Manually set up the Internet connection on page 35.)
7. Select an IP Address Assignment radio button:
• Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive an IPv6 address through a
DHCP server.
• Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
home network (the LAN).
8. (Optional) Select the Enable RIPng check box.
This selection enables RIP Next Generation (RIPng) on IPv6 Internet connections.
RIPng is an extension of Routing Information Protocol (RIP) that supports IPv6. You
might want to enable RIPng if you are an advanced user with a complex home network
configuration that requires dynamic routing.
9. In the IPv6 Address/Prefix Length fields, specify the static IPv6 address and prefix
length of the router's LAN interface.
If you do not specify an ID here, the router generates one automatically from its MAC
address.
10. Click the Apply button.
Your settings are saved.

Set a DHCP IPv6 Internet connection

To set a DHCP IPv6 Internet connection:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
49 User Manual