82
4.
FRAME
-
-
---~-.
~--,.....~~~
----
.
~
-
-
~
fig. 4. 40
(D
Seat
fig. 4. 41
CD
Seat
Fig. 4.42
CD
Air cleaner cover
~--
-
fig
.
4. 43
Removing the seal
©
Seat setting
bolts
®
Seat latch lever
®
Air
cleaner case
4. 7
Seat and Air Cleaner Case
A.
Construction
The motorcycle is equipped with a double seat
consisting of 4 layers of sponge rubber padding
to isolate the
vibration
from being transmitted to
the
rider.
The rear and center sections of the seat
are padded
thicker
to prevent the rider from sliding
on the seat during sudden starting and acceleration.
Seat covering is a vinyl leather for greater strength,
further, it is easier to keep clean.
The inspection and replacement of the electric
equipment such as the battery, selenium rectifier and
magnetic starter switch can be easily performed
by unlatching
the
seat lever
located
at the front
left side and raising the seat which is hinged at
the back. (Fig. 4. 40~4 l)
The air cleaner
case which
houses the air cleaner
elerr.ent rr:cde of corrugated cellulose fiber is con-
structed
of
pressed steel sheet to adequately protect
the
cleaner. (Fig.
4. 42)
B.
Disassembly
l
.
Raise the seat and remove
the
two bolts at
the seat
hinge and separate seat from the frame.
(Fig. 4. 43)
2.
The seat stay a can be separated from the
seat by unscrewing the 6 mm nuts.
3.
Air cleaner cover is removal by pulling out on
the cover.