Honda CB450 1968 Service Manual page 112

4. 14 REA R WHEEL
10 1
8. Disassembly
l. Remove the drive chain joint, and disconnect
the chain. (Fig. 4 . 90)
2 . Remove the rear broke ad justing nut; separa te
the bro':e rod fro m the broke arm; remove the
rear broke stop bol t, and separa te the stop arm
fr om the panel.
3 . Extract the cotter pin from the axle.
4 . Remove the rear ax le nut and extra ct the rear
whee l axle. Ti lt the rear wheel, and remove.
(Fig. 4. 91)
5 . Remove hub bearing retainer cop and 73.8mm
circlip, straig hten the tongue washer, and remove
t he l O mm nut. The frnol dr iven sprocke t can
then be separated from the rear wheel hub.
(Fig. 4. 92)
6. Use the special too l (rear wee( bear ing retainer
wrench) and remove the rear whee l bearing
retainer. Pull out the 6304 Z and 6305 Z ba ll
beari ngs, and rear axle spacing co llar . (Fig.4. 93)
fig. 4. 90 Removing the drive chain cli p
CD
Drive chai n
@
Drive chain cli p
f ig.
4 .
91 Remov ing the rear wheel
CD
Rear wheel
4. 92
Remov ing the final driven sprod et
CD
73. 8 rrim ci rc lip
CI)
f inal dr iven sprocket
@
10
mm nut
Fig .
4.
93 Removing the bear ing retainer
CD
Bearing reta iner extr actor
@
Bearing retain