Honda CB450 1968 Service Manual page 79

68
Fig .
4.
5 Removing the thro tt le coble
G)
Throttle grip
®
Throttle cab le
@
Starter switch assembl y
Fig. 4. 6 Removing the throttle cable
G)
Throttle cable
@
Throttle cab le adiusler
@
Lock nut
Fig. 4. 7
Removing the handlebar
G)
Handleber cable
®
Throttle cable
@
Electrical leads
4.
FRAME
3. To remove throttle cable from the handle
lever, unscrew the setting screw on the starter
switch assembly and separate the two halves of
the starter switch. The starter cable will be
exposed and can be removed from throttle grip
pipe. (Fig. 4. 5)
4. Disconnect the throttle cable at the lower end
by loosening the cable setting nut at the cable sup-
port arm on the carburetor and then disconnecting
the thrott le coble from the carburetor.
(Fig. 4. 6)
5. The electr ica l leads for the horn, starting
motor switch and the light dimmer switch can be
disconnect by uncoupling the cable junctions from
the wire harness located within headlight case.
6. Remove handle bar by unscrewing the four
bolts from the handle pipe holder clamps. (Fig.
4. 7)