Edit User Data; Add Apparatus Models - Honeywell Posi 3 Setup Manual

4. Set the Permissions level as needed.
5. Click on the Check button to save the
information.
6. Click Done when finished adding users.
6.3.3

Edit User Data

To edit an existing user's information, enter
the User List as described above and click on
the up arrow.
Once the user's information has been
changed, click on the Check button to save
the information.

6.4 Add Apparatus Models

Note: The Model Configuration Wizard is
only available in Standard Version Posi 3
USB software. Brand-specific versions of
software come with pre-installed models and
do not allow end users to configure models.
All SCBA are made up of similar components
including a facepiece, a first stage regulator,
a second stage regulator, alarms, gauges
and an air cylinder. Although every SCBA is
unique, there are general similarities from
model to model that Honeywell Analytics
uses to set the appropriate baseline values
for testing these components.
The Model Configuration Wizard allows the
user to select components to create specific
models from the available of SCBA, Airline
Apparatus, and Facepieces that are used in
testing.
Once the type of apparatus is selected, the
Model Configuration Wizard will automatically
run through the appropriate setup procedure.
The user will need to configure the model so
that it matches the physical specifications of
the apparatus.
The testing procedure is automatically
defined for the apparatus model that is
selected at the time of testing. That
apparatus is configured in the software by
this procedure.
The user entering apparatus information
must have level 4 software access or the Add
New Model and/or Add New Serial Number
options may be unavailable. See section
6.3.1 for a description of user software
permissions.
1. To enter a new apparatus, first select
Setup / Apparatus / Add New Model.
2. The Choose Model Screen will be shown
and will show a list of all models that are
available for testing. If this is the initial
software launch, the fields will be blank.
3. Click on New to enter the Model
Configurator.
20