Physical Description Of Fdap; Fdap Enclosure; Figure 2 - Physical Description Of Fdap - Honeywell 51306533 User Manual

3.4

Physical description of FDAP

The FDAP has a rugged die-cast aluminum enclosure for outdoor use. The primary
subassemblies of the enclosure are the base housing and the cover. The enclosure and all
auxiliary components are designed for IP66 and NEMA Type 4X ratings for protection
against contact with dust and powerful water jet from all directions. The enclosure has
two antenna ports for receiver spatial diversity in the FDAP radios. The antenna holes
use type N threaded bulkhead RF connectors which is inherently watertight to MIL-STD-
202, method 106. The ½" rigid conduit hub has a gasket to seal out water and dust. A
rigid conduit hub, internal and external ground studs, and removable cover are provided
for field installation. Externally accessible IR port and status LEDs allows you to
commission the FDAP and get status information, respectively. The IR port and LED
holes are covered with an outdoor rated adhesive backed Lexan
can mounted on a pole or on wall.

FDAP enclosure

The FDAP enclosure is rugged and compact. The enclosure measures approximately 20
cm x 13 cm x 7 cm (L x W x H). The heavy ribbing of the enclosure provides large
surface area for heat sinking, stiffens the cover and housing to minimize deflection, and
reduces number of screws for the cover. The FDAP enclosure assembly also includes
R200 OneWireless Field Device Access Point User's Guide
October 2010
Figure 2 – Physical description of FDAP
Honeywell Confidential & Proprietary
3. About FDAP
3.4. Physical description of FDAP
TM
label. The enclosure
25