Table of Contents
Advertisement
11
Select the backup destination and click OK.
12
Click OK. Jobs will be added to the backup list.
Notes:
• Up to 8 backup jobs can be configured.
• To back up data between Buffalo NAS devices on a network using jumbo frames, make sure that both devices are
configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly different, the
backup job may not be properly performed. In such a case, select the default frame size (1500 bytes).
• You can also specify a hostname by a fully qualified domain name (FQDN).
• Windows-based TeraStations with multibyte characters in the hostname may not be detected as a backup
destination, and folders in these devices cannot be used as backup destination folders.
Backup Logs
The following backup error codes may be recorded in the backup log. Read the description and try the respective
corrective actions for each error.
Code
Description
The backup destination USB
Code 3
drive could not be found.
The backup destination shared
Code 5
folder could not be found.
The Ethernet cable was
disconnected from the backup
Code 10
source TeraStation when the
backup job started.
Corrective Action
Verify that the backup destination
USB drive is connected to the
TeraStation properly.
Verify that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on.
Reconnect the Ethernet cable.
87
Log Example
rsync error: errors
selecting input/
output files, dirs (code
3) at main.c(634)
[Receiver=3.1.0]
Can't write to backup
destination(target
disk is broken?).
rsync error: error
starting client-server
protocol (code 5) at
main.c(1504)
rsync error: error in
socket IO (code 10)
at clientserver.c(128)
[sender=3.1.0pre1]
Advertisement
Table of Contents
