Table of Contents
Advertisement
9
Drive Lock (
Open the front panel with the key to replace hard drives or access the reset button.
10
Reset Button
To shut down and reboot the TeraStation, press and hold the reset button.
11
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If a drive fails, its LED will turn red or amber.
12
VGA Port
Factory use only.
13
Boot Mode Switch
Leave the switch in the HDD position during normal operation. To recover settings, insert the recovery USB
drive into a USB 2.0 port, move the boot switch to the USB position, and press the power button.
14
UPS Port
Connect to a UPS.
15
USB 3.0 Port (
Compatible Buffalo USB 3.0 hard drives can be connected. USB hubs are not supported.
16
USB 2.0 Port (
Compatible Buffalo USB hard drives, USB flash drives, digital cameras, and USB UPS connections can be
connected. USB hubs are not supported.
17
LAN Port 1 (
)
Use an Ethernet cable to connect this port to your network.
18
LAN Port 2 (
)
This second Ethernet port may be used for network redundancy or backup. You may connect a second
TeraStation directly to this port for backup.
19
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
20
Fan
Spins to avoid overheating inside. Do not block the fan.
21
Anti-Theft Security Slot (
Use this slot to secure your TeraStation with a cable lock (not included).
22
Link LED
Glows amber when the unit is connected to a network.
23
Act LED
This LED shows network activity. It blinks amber when the TeraStation is accessed over the network.
Turning the TeraStation On and Off
Press the power button on the TeraStation to turn it on.
)
)
)
)
10
Advertisement
Table of Contents
