Table of Contents
Advertisement
4
From "Target USB drive", select the USB drive that is connected to the USB 2.0 port on the TeraStation.
5
Select "Save current configuration to a USB drive", then click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will save the settings. When saving settings is finished, click OK.
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive an error message such as "The specified
operation cannot be executed. " . Verify:
• The USB drive is connected to a USB 2.0 port, not a USB 3.0 port.
• The USB drive has a capacity of 1 GB or larger.
• The USB drive is not write-protected.
Applying Settings
The saved settings can be applied to a different TeraStation of the same series. If applying settings to another
TeraStation, the unit's current firmware version will be changed to the version used to save the settings.
1
Insert the USB drive with the saved settings to a USB 2.0 port on the TeraStation.
2
In Settings, click Management.
3
Click
to the right of "Restore/Erase".
201
Advertisement
Table of Contents
