Service Configuration Page - ABB FBIP-21 BACnet/IP User Manual

66 Appendix C - FBIP-21 configuration web pages
After you have changed any setting in any of the groups, you must click Save and
reboot at the bottom of Group A to validate the settings.

Service configuration page

￭
On the Service configuration page, you can enable or disable certain Ethernet services.
All services except Simple Network Time Protocol (SNTP) are enabled by default. You
can disable the following services on this page:
• access to FBIP-21 configuration web page
• allow to change IP settings remotely via ABB IP configuration tool
• remote access drive with Drive composer tool via Ethernet tool network
• Ping response
• configure SNTP
The new settings take effect after reboot of the module. You can click Save and reboot,
to validate the new settings immediately or click Save without rebooting if you want
to do other settings also and then reboot.