Replacing The Battery - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Replacing the Battery

When inserting a fan module into the SCE 2000 platform, do not use unnecessary force; slamming the
Warning
fan module into the chassis can damage the connectors on the rear of the module.
Seat the fan module in the SCE 2000 platform by tightening the two captive installation screws
Step 4
with a 1/4-inch flat-blade screwdriver.
The fan module is not fully seated until you tighten the installation screws on the faceplate.
Note
This completes the procedures for replacing a fan module in a SCE 2000 platform.
Replacing the Battery
The SCE 2000 has a lithium battery on its main circuit board. When the battery loses its charge,
call Cisco Technical Support to replace the battery.
Do not attempt to replace this battery yourself
Warning
There is danger of explosion if the lithium battery is incorrectly replaced. Replace only with the same
Warning
or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
4-22
Chapter 4 Installation and Maintenance
OL-7824-04