Cisco SCE 2000 4xGBE Installation And Configuration Manual page 137

Appendix A The External Optical Bypass Module
Figure A-4: Bypass Connectors on the Rear of the SCE 2000
The following figure illustrates the connectivity of the External Optical Bypass module.
To cable the External Optical Bypass module:
Step 1 Connect an optical cable (user supplied) between the GBE port on the Subscriber side network
element and the SUB port on the External Optical Bypass module.
Step 2 Connect an optical cable (user supplied) between the GBE port on the Network side network
element and the NET port on the External Optical Bypass module.
Verify that the links between the two network elements are active.
Connect the SUB cable of the fiber of the External Optical Bypass module to the SUB GBE port
Step 3
of the SCE 2000 platform.
Rx <-> Tx
Step 4 Connect the NET cable of the fiber of the External Optical Bypass module to the NET GBE port
of the SCE 2000 platform.
Rx <-> Tx
Power up the SCE 2000 platform, as explained in
Step 5
Conditions
OL-7824-04
Connect the control cable to the Bypass 2 9-pin D-Type connector on the rear panel of the
•
SCE 2000 platform.
(on page 7-2).
Starting the System and Observing Initial
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Installing the External Bypass Module
A-5