Step 9: Configuring The Topology-Dependent Parameters - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Initial System Configuration
Enable the SCE enterprise traps []:
Type the name of the system administrator and press Enter.
Step 16
Note that there is no default for this parameter.
Enter system administrator contact name []:
E
XAMPLE
Following is a sample SNMP configuration, configuring one trap manager, one GET community,
and one SET community, and enabling the authentication failure trap, as well as all enterprise
traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0'
to allow all: 0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0'
to allow all: 2
Would you like to add another SNMP SET community? [no]:
Would you like to configure SNMP trap managers? [no]: y
Enter SNMP trap manager IP address: 10.1.1.253
Enter SNMP trap manager community string: public
Enter trap manager SNMP version: 2c
Would you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: y
Enable SCE enterprise traps []: y
Enter system administrator contact name []: John Smith

Step 9: Configuring the Topology-Dependent Parameters

The topology configuration menu is a series of guided questions relating to the deployment of the
SCE 2000 in the network and its mode of operation. Values for the parameters are configured
based on the user answers.
The correct value for each parameter must be ascertained before configuring the system to make
sure that the system will function in the desired manner. (See
comprehensive discussion of topology and the related parameters.)
Values may not be requested for all topology-dependent parameters, as certain parameters do not apply
Note
to all topologies.
There are six topology-related parameters:
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-18
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To enable the SCE enterprise traps, type y and press Enter.
•
:
• Connection mode — Can be either of the following, depending on the physical installation
of the SCE 2000.
Inline
•
Receive-only
•
Topology (on page 3-1) for a
OL-7824-04