Cabling The Gbe Port - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Connecting the line ports to the network
Table 6-1
SCE Model
SCE 2000 4xGBE
MM
SCE 2000 4xGBE
SM

Cabling the GBE Port

Warning Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.
To cable the SCE 2000 GBE line port, complete the following steps:
Step 1 Take the appropriate fiber optic cable (see
appropriate GBE port on the front panel of the SCE 2000.
Make sure to push on the connector until you hear a click, which indicates that the connector is
fully inserted and secured in the receptacle. Always make sure that you insert the connector
completely into the socket.
Figure 6-6: Cabling the GBE Interface
Step 2 Verify that the link LED is green.
If the link LED does not light, try removing the network cable plug and reinserting it firmly into
the module socket.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-8
Chapter 6
Fiber Specifications
Transceiver
850nm Multimode
1310nm FRP laser
Single Mode
Cabling the Line Ports and Completing the Installation
Transmit Power Receive Power Typical (Max.) Distance
–9.5 to –4 dBm –17 to 0 dBm
–9.5 to –3 dBm –20 to 3 dBm
Fiber Specifications (on page 6-7)) and plug it into the
• 750m for 50µm Core
Diameter MMF
• 400m for 62.5µm Core
Diameter MMF
10 km for 9.0µm Core
Diameter SMF
OL-7824-04