Enabling Server Disk Capacity Monitoring - Cisco 700 MHz Installation And Upgrade Manual

Chapter 6 Maintaining the Cisco Unified MeetingPlace Audio Server System
SCSI Adapter:
Ethernet:
Modem:
Smart Blades:

Enabling Server Disk Capacity Monitoring

You can monitor the disk use of the Cisco Unified MeetingPlace Audio Server system. The Cisco
Unified MeetingPlace system raises an alarm when it reaches or exceeds a specified use threshold.
Threshold values denote the percentage of a particular file system that is currently being used. In
general, 90 percent is a good value for a threshold. You can use a number lower than 90 to get an earlier
warning, but you may get an alarm for a normal condition. We recommend using 90.
To Enable Server Disk Capacity Monitoring
Step 1 Log in to the CLI as a technician. The tech$ prompt appears.
Step 2 Log your terminal session. (For information on logging, see the
section on page
Enter configdiskcap.
Step 3
Step 4 Enter the number of the file whose use threshold capacity you want to modify. In
to modify the use threshold capacity for the /lat/db file (file 2), so enter 2.
Enter the new use threshold value for this file. In
Step 5
95 percent, so enter 95.
Save your changes and exit the configdiskcap command by entering s.
Step 6
Example 6-2
meetingplace:tech$ configdiskcap
+++++++++++++++++++++++++++++++++++
Disk Capacity Monitor Configuration
+++++++++++++++++++++++++++++++++++
Capacity values are utilization percentage thresholds.
A major alarm will be raised if a threshold is exceeded.
Select a file system threshold to modify when prompted.
Values must be between 60 and 99; a capacity
of 0 disables checking for that file system.
1) 0
2) 0
OL-13417-01
PS2: OK, fan is OK
PS3: OK, fan is OK
NCR 810
DISK 1: 36000MB (SEAGATE
DISK 2: 36000MB (SEAGATE
Solid State Disk: IMPERIAL "MG-35/400 ULTRA" S/N=0128 REV=B403
Battery: usage = 307 days, charge is OK
Intel 8225x PCI 10/100 (0001af03c05e)
Absent or unrecognized
Slot 16: NMS CG6000C S/N=20363257 REV=5894-B2 MSC0 PRC0
Slot 15: NMS CG6000C S/N=20363261 REV=5894-B2 MSC1 PRC1
3-3.)
Enabling Server Disk Capacity Monitoring
CAP% FILESYSTEM
==== ==========
/
/lat/db
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
Enabling Server Disk Capacity Monitoring
ST336704LW REV=0004)
ST336704LW REV=0004)
"Logging Your HyperTerminal Session"
Example 6-2, we want the use threshold capacity to be
Example 6-2, we want
6-3