Troubleshooting Telephony Configuration - Cisco 700 MHz Installation And Upgrade Manual

Troubleshooting Telephony Configuration

Troubleshooting Telephony Configuration
To Troubleshoot Telephony Configuration
Check that the information you entered into MeetingTime from the worksheets in the Installation
Step 1
Planning Guide for Cisco Unified MeetingPlace is correct.
Check all the physical connections to the Cisco Unified MeetingPlace Audio Server system.
Step 2
For the Cisco Unified MeetingPlace 8112, check that no LEDs are in a bad state. (Refer to the
Step 3
Administration Guide for Cisco Unified MeetingPlace Audio Server at
http://www.cisco.com/en/US/products/sw/ps5664/ps5669/prod_maintenance_guides_list.html
explanation of the LEDs.)
Step 4 If you made any changes to the MeetingTime configuration, access the CLI and enter restart.
Step 5 After the Cisco Unified MeetingPlace Audio Server system comes back up, repeat the testing
procedures.
If these actions do not correct the problem, contact Cisco TAC. (See the
Obtaining Support, and Security Guidelines" section on page
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
7-2
Chapter 7 Troubleshooting the Cisco Unified MeetingPlace Audio Server System Installation
"Obtaining Documentation,
x.)
for an
OL-13417-01