Cisco 700 MHz Installation And Upgrade Manual page 45

Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Repeat
Step 7
For the Cisco Unified MeetingPlace 8106, place the second trunk card cable assembly into the
connectors on the left of the breakout box and on the left of the Multi Access Blade.
For the Cisco Unified MeetingPlace 8112, place the second trunk card cable assembly into the
connectors on the left of the breakout box and on the bottom of the Multi Access Blade.
Figure 2-17
configuration supports 480 E1 ports with one Multi Access Blade card MP-MA-16-PRI.
Figure 2-17
Figure 2-18
configuration supports 480 E1 ports with one Multi Access Blade card MP-MA-16-PRI.
OL-13417-01
About Telephony Configurations for E1 and T1 PRI Cisco Unified MeetingPlace Systems
Step 5 and Step 6 for the second trunk card cable assembly (50-pin Amphenol cable).
shows the connections on the back of a Cisco Unified MeetingPlace 8106. This
Back of Cisco Unified MeetingPlace 8106 (E1 with 1 MP-MA-16-PRI)
shows the connections on the back of a Cisco Unified MeetingPlace 8112. This
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
2-21