Installing And Connecting The Modem - Cisco 700 MHz Installation And Upgrade Manual

Installing and Connecting the Modem

Plug the other end of the first T1 CAS telephony cable into the T1 Smart Blade transition module in the
Step 3
back of the Cisco Unified MeetingPlace Audio Server.
For the Cisco Unified MeetingPlace 8106, place the first T1 CAS telephony cable in the left most
connector slot. Place the second T1 CAS telephony cable in the next connector slot moving to the right,
and so on.
For the Cisco Unified MeetingPlace 8112, place the first T1 CAS telephony cable in the topmost
connector slot. Place the second T1 CAS telephony cable in the next connector slot moving down, and
so on.
You can connect a maximum of four T1 CAS telephony cables to any one T1 Smart Blade transition
module.
Repeat
Step 4
Install tie wraps and label the T1 CAS telephony cables as needed.
Step 5
Attach the far end of the IP LAN cable to the RJ-45 socket of the switch or other network equipment.
Step 6
Plug the other end of the IP LAN cable into the Ethernet 1 connector on the Multi Access Blade
Step 7
transition module.
If your configuration uses two Multi Access Blades, repeat
Step 8
Installing and Connecting the Modem
To Install and Connect the Modem
Step 1 Locate the following items that shipped with the Cisco Unified MeetingPlace Audio Server:
•
•
•
•
Step 2 If you have a T1 CAS or a pure IP Cisco Unified MeetingPlace system, place the modem on the back
right corner of the Cisco Unified MeetingPlace Audio Server. The modem cable connections must face
the back of the Cisco Unified MeetingPlace Audio Server. Do not move the modem from this space.
If you have a T1 PRI or an E1 Cisco Unified MeetingPlace system, place the modem into the empty slot
on the far left of the breakout box. See
Step 3 Confirm that the modem power switch is in the off position. The modem power switch is on the side of
the modem.
Looking at the back of the Cisco Unified MeetingPlace Audio Server, connect the modem power cable
Step 4
to the far left position on the back of the modem.
Connect the other end of the modem power cable into the power outlet.
Step 5
Looking at the back of the Cisco Unified MeetingPlace Audio Server, connect the phone extension cable
Step 6
to the far right position on the back of the modem, labeled "Line." Two RJ-11 connectors are on the
modem. Place this cable in the far right connector.
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
2-36
Step 2 and Step 3 until all the T1 CAS telephony cables are connected.
Modem.
Modem cable.
Modem power cable.
Phone extension cable.
Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Step 6
Figure 2-14. Do not move the modem from this space.
and Step 7.
OL-13417-01