Table of Contents
Advertisement
6.5
Operation of the machine
6.5.1 Turning on the CNC- machine
Switch on the main switch.
Wait until the control is completely started.
Press the push button "Drive control ON"
Unlock the "Emergency Stop push buttons"
- on the spindle head (not visible in the picture),
- on the MCP,
- on the electronic handwheel.
Close - if not yet closed - the sliding door.
Press the push button "Reset"
2
Img.6-2:
Operating area
6.5.2 Reference point approach after turning on
INFORMATION
After turning on the G0876 must first be referenced. Without existing reference
points (machine zero points) you cannot start and run programs in the control.
With the beginning of the reference point approach the axes should be located in a
central position as possible.
The following information indicated serve as preliminary information. Further
information can be found in the Siemens manual.
Model G0876 (Mfd. Since 3/19)
"Lockable main switch" on page 15
.
1
.
2
.
3
3
2
1
-55-
Advertisement
Table of Contents
