First Commissioning - Grizzly G0876 Owner's Manual

3.4

First commissioning

3.4.1 Refilling the cooling lubricant
INFORMATION
The CNC machine is delivered without cooling lubricant.
Fill the coolant / lubricant tank with an appropriate cooling lubricant via the machining room

CNC machine.

Img.3-3: Level indicator coolant / lubricant
ATTENTION!
Failure of the pumps in case of dry running. The pumps are lubricated by the cooling
lubricant. Do not start up the pumps without cooling lubricant.
INFORMATION
Use a water-soluble environmentally friendly emulsion as cooling lubricant procured
from a specialist retailer.
Make sure that the cooling lubricant is properly absorbed.
Respect the environment when disposing of lubricants and coolants. Follow the
manufacturer's disposal instructions.
3.4.2 Cooling lubricants
INFORMATION
The lathe is lacquered with a
ing lubricant.
The company Grizzly Industrial, Inc. does not assume any guarantee for subsequent
damages due to unsuitable cooling lubricants.
The flashpoint of the emulsion must be higher than 140°C.
When using non-water-miscible cooling lubricants (oil content > 15%) with a flashpoint, ignitable
aerosol air mixtures might develop. There is a potential danger of explosion.
The selection of cooling lubricants and slideway oils, lubricating oils or greases as well as their
care are being determined by the machine operator or operating company.
Therefore, Grizzly Industrial, Inc. cannot be held liable for machine damages caused by
unsuitable coolants and lubricants as well as by inadequate maintenance and servic-ing of the
coolant. In case of problems with the cooling lubricant and the slideway oil or grease, please
contact your mineral oil supplier.
Model G0876 (Mfd. Since 3/19)
"Cooling lubricants" on page 243
one-component paint. Consider this fact when selecting your cool-
Level indicator
-31-