Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
After clicking the Edit button, the following page will appear.
The fields that can be configured are described below:
Parameter
MEP State
CCM State
PDU Priority
Fault Alarm
Figure 10-7 CFM Settings (Add MA, Add MEP, MEPID Detail, Edit) Window
Description
Select to enable or disable the MEP state on the interface here.
Select to enable or disable the CCM state here.
Select the PDU priority value here. The range is from 0 to 7. This feature is
used to define the 802.1p priority that is set in the CCM and other CFM PDUs
transmitted by the MEP.
Select the type of defects whose fault alarms can be sent by this MEP. Options
to choose from are None, All, MAC-Status, Remote-CCM, Error-CCM, and
XCON-CCM.
• None - Specifies that no fault alarm will be sent.
• All - Specifies that the fault alarms can be sent for all types of defects.
• MAC-Status - Specifies that the fault alarms can be sent for the defects
whose priority is equal to or higher than DefMACstatus.
• Remote-CCM - Specifies that the fault alarms can be sent for the defects
whose priority is equal to or higher than DefRemoteCCM.
• Error-CCM - Specifies that the fault alarms can be sent for the defects
whose priority is equal to or higher than DefErrorCCM.
• XCON-CCM - Specifies that only the fault alarm of DefXconCCM can be
sent.
382
Advertisement
Table of Contents
