Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
To view the following window, click Management > SD Card Management > SD Card Execute Settings, as shown
below:
The fields that can be configured in Execute Configuration are described below:
Parameter
File URL
Increment
Click the Apply button to accept the changes made.
The fields that can be configured in SD Card Execute Settings are described below:
Parameter
Execute Entry Name
Time Range
Mode
File Name
State
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Figure 4-659 SD Card Execute Settings Window
Description
Enter the URL of the file here. If the current directory is not the directory of SD
card file system, then the full file path must be entered.
Select to enable or disable the increment feature here.
• When enabled, the current configuration will not be cleared before
executing the configuration.
• When disabled, the current configuration will be cleared before executing
the configuration.
Description
Enter the name of the execution entry here. This string can be up to 32
characters long.
After clicking the Edit button, enter the time range schedule that will be used
here.
After clicking the Edit button, select the mode here. Options to choose from
are:
• Increase - Specifies that the current configuration will not be cleared
before executing the configuration.
• Reset - Specifies that the current configuration will be cleared before
executing the configuration.
After clicking the Edit button, enter the source filename and path that will be
executed here.
After clicking the Edit button, select to enable or disable this schedule here.
97
Advertisement
Table of Contents
