Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured in IP-MAC-Port Binding Trap Settings are described below:
Parameter
Trap State
Click the Apply button to accept the changes made.
The fields that can be configured in IP-MAC-Port Binding Port Settings are described below:
Parameter
Unit
From Port - To Port
Mode
Click the Apply button to accept the changes made.
IP-MAC-Port Binding Blocked Entry
This window is used to view and clear the IP-MAC-Port binding blocked entry table.
To view the following window, click Security > IMPB > IPv4 > Advanced Settings > IP-MAC-Port Binding Blocked
Entry, as shown below:
Figure 9-54 IP-MAC-Port Binding Settings Window
Description
Select the enable or disable the IP-MAC-Port binding option's trap state.
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select the mode of access control that will be used here. Options to choose
from are Disabled, Strict, and Loose. When a port is enabled for IMPB strict-
mode access control, a host can only access the port after the host sends ARP
or IP packets and the ARP packet or IP packet sent by the host passes the
binding check. To pass the binding check, the source IP address, source MAC
address, VLAN ID, and arrival port number must match any of the entries
defined by either the IP source guard static binding entry or the DHCP
snooping learned dynamic binding entry. When a port is enabled for IMPB
loose-mode access control, a host will be denied to access the port after the
host sends ARP or IP packets and the ARP packet or IP packet sent by the
host does not pass the binding check. To pass the binding check, the source IP
address, source MAC address, VLAN ID, and arrival port must match any of the
entries defined by either the IP source guard static binding entry or the DHCP
snooping learned dynamic binding entry.
336
Advertisement
Table of Contents
