Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured in OSPF Interface Table are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the Interface Name link to access and configure the specified OSPFv3 process.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Interface Name link button, the following page will appear.
The fields that can be configured are described below:
Parameter
Cost
Hello Interval
Dead Interval
Priority
Description
Enter the name of the interface here.
Figure 6-61 OSPFv3 Interface Settings (Interface Name) Window
Description
Enter cost value here. It is an integer value expressed as the link-state metric.
The range is from 1 to 65535.
Select the Default option to use the default value.
Enter the Hello Interval value, between the hello packets that the router sends
on an interface here. This value is advertised in the hello packets. The shorter
the Hello Interval, the earlier topological changes will be detected, but more
routing traffic will ensue. This value must be the same for all routers and access
servers on a specific network. The range is from 1 to 65535 seconds.
Select the Default option to use the default value, which is 10 seconds.
Enter the Dead Interval value here, during which no packets are received and
after which a neighbor is regarded as offline. The interval is advertised in router
hello packets. This value must be the same for all routers and access servers
on a specific network. The range is from 1 to 65535 seconds.
Select the Default option to use the default value, which is 40 seconds.
Enter the priority value of the router here. The range is from 0 to 255. Set the
priority to help determine the OSPF Designated Router (DR) for a network. If
225
Advertisement
Table of Contents
