Introduction; Applicable Part Numbers Subsection Description; Function Subsection Description; Requirements And Limitations Subsection Description - Honeywell BENDIX KING KMH 880 System Installation Manual

B B B B
3.0

INTRODUCTION

You will find information relative to the KMH 880/KTA 870 system requirement options
available to the system planner and the electrical characteristics of the various interfaces
in Section III. You will also find pin function lists and interconnect diagrams in this section.
Section III contains interconnect family diagrams for the KMH 880/KTA 870 system.
Refer to figure 3-3 for the KMH 880/KTA 870 system diagram. There are several intercon-
nect drawings for popular equipment that interface with the KMH 880/KTA 870. The
installing agency should contact Honeywell International Inc. Product Support at (800)
257-0726 for information regarding the compatibility of equipment not listed in this man-
ual. Normal business hours are 8:00 A.M. to 5:00 P .M. CST, Monday through Friday.

3.0.1 Applicable Part Numbers Subsection Description

Information given in this section pertains only to the KMH 880/KTA 870 System
using part numbers. Refer to Section 1.4.1 for complete part number descriptions.

3.0.2 Function Subsection Description

Detailed information concerning the purpose and operation of the interface are
described in this section.

3.0.3 Requirements and Limitations Subsection Description.

Any operational requirements or limitations relating to the interface are described
in this section. Widely followed regulatory requirements may also be described
here. Regionally enforced requirements vary greatly and adherence to them
remains the responsibility of the installing agency.

3.0.4 Electrical Characteristics Subsection Description.

The electrical characteristics and format of the interface signals are described in
this section. Any flavor-related differences in signal format are also described
here. Overlined pin names generally indicate active low signals, although the
absence of an overline does not necessarily indicate an active high signal.

3.0.5 Interface Subsection Description

The harness techniques for shielding and shield termination described in this
manual are identical to those specified for the test harness used during HIRF and
Lightning testing. Adherence to the information in this manual is essential in
establishing an installation environment equivalent to the test environment used
during HIRF and Lightning testing.
Rev 0, October/2000
SECTION III
SYSTEM PLANNING
10609I00.ZIPCDL
KMH 880/KTA 870
Page 3-1