Configuration Sequence Of Events; Configuration Types - Honeywell BENDIX KING KMH 880 System Installation Manual

B
4.2.3.5 Configuration Sequence of Events (Application)
A. Turn the KMH 880 system power on.
B. Bring up the WINVIEWS program. Type Ctrl Z.
C. At the WINVIEWS prompt type "CFG". Press the ENTER key.
D. Type in the pre-configured STRING using the command "CUW". Press the
ENTER key.
E. After loading this string in the WINVIEWS, the cursor will flash waiting for
an answer "Y" or "N".
F. Type "Y".
G. When, the system comes back up type Ctrl "Z" then type "PS" (Present
Status).
H. Check the Status information displayed. Confirm that your configuration
input write is accurate.
4.2.3.6 Configuration Types (Categories)
The selection of the basic interfaces to the EGPWS can be found in the following catego-
ries.
Aircraft/Mode Type
Air Data Type
Position Type
Terrain Display Type
I/O Discretes Types
Audio Menu Type
Audio Output Level Type
Altitude Monitor Options Type
Terrain Display Alternate Pop up Option
4.2.3.7 Configuration Identification Selection (ID)
The method to select the Configuration Identification (ID) for each Category Type on a
given aircraft installation is with the information in this document and the following table.
Page 4-4
NOTE
At this point the EGPWS will reboot itself.
10609I00.ZIPCDL
KMH 880/KTA 870
Category 1
Category 2
Category 3
Category 4
Category 5
Category 6
Category 7
Category 8
Category 9
Rev 0, October/2000