Table of Contents
Advertisement
B
5.0
INTRODUCTION
This section outlines the procedures required to obtain IFR certification for the KMH 880/
KTA 870 System. Recommended flight test procedures are also included.
5.1
CERTIFICATION PROCEDURE
5.1.1
Equipment Compatibility
Careful consideration must be paid to the electrical characteristics of existing
equipment or possible additions that will be interfaced with the KMH 880/KTA
870 System, in order to ensure system compatibility. Section III of this manual
provides system planning guidelines, and defines the electrical characteristics
of the KMH 880/KTA 870 System. The installing agency should contact Honey-
well International Inc. Product Support at (800) 257-0726, for information
regarding the compatibility of equipment not listed in Section III. Normal busi-
ness hours are 8:00 AM to 5:00 PM Central Time, Monday through Friday.
The TAS system may operate in conjunction with, and in close proximity to, a
transponder. The functions of the system will not in any way degrade the per-
formance of the transponder beyond its specified limits.
All of the TAS requirements stated in this document will be met when the TAS
equipment is operating in conjunction with a compatible operating transponder,
except when the transponder is active. The active state of the transponder is
defined as the greater of the time interval between (a) the leading edge of the
first transmitted pulse of the transponder reply minus 10 microseconds and the
trailing edge of the last transmitted pulse of that reply plus 10 microseconds, or
(b) the time interval during which a mutual suppression occurs.
5.1.2
Equipment Location
The KMH 880/KTA 870 System and associated indicators, annunciators and
switches should be clearly visible and within easy reach of the pilot. Refer to
Section II of this manual for complete installation information.
Rev 0, October/2000
SECTION V
CERTIFICATION
10609I00.ZIPCDL
KMH 880/KTA 870
Page 5-1
Hide quick links:
Advertisement
Chapters
Table of Contents
