Honeywell BENDIX KING KMH 880 System Installation Manual page 191

B
the word "TEST" is displayed on the display. The following symbols are dis-
played:
• Traffic Advisory (yellow circle) will appear at 9 o'clock, range of 2 miles,
200 feet below and climbing.
• Proximity traffic (solid white diamond) will appear at 1 o'clock, range 3.6
miles, 1000 feet below and descending.
• Non-threat traffic (open white diamond) will appear at 11 o'clock, range
of 3.6 miles, flying level 1000 feet above.
At the conclusion of a successful self-test, a synthesized voice announces,
"TAS System Test OK". Should a failure be detected during self-test, the
audio message says, "TAS System Test Fail".
E. Perform the Ground Test.
Ground tests are necessary to meet the requirements of DRAFT AC 20 ZZ.
While the tests are organized in a sequential fashion, they may be com-
pleted in a random order to accommodate other conditions. The person
performing these tests should be familiar with the TAS equipment, the air-
craft installation and the supporting test equipment.
In the following test results space "_____", enter "P" for Passed, "F" for Failed
and/or fill in the results or comments. If the section does not apply, write N/A.
1. Perform the TAS Power Checks
Verify aircraft power to TAS
Pull the 5 amp TAS Processor circuit breaker.
Verify that the "TAS" flag appears on the traffic display.
Reset the circuit breaker. Verify that the flag clears.
Pass/Fail _____.
Pull the 1 amp TAS Control circuit breaker.
Verify that the "TAS" flag appears on the traffic display.
Reset the circuit breaker. verify that the flag clears.
Rev 0, October/2000
NOTE
10609I00.ZIPCDL
KMH 880/KTA 870
Page 4-21